Pacific F-Pro Hard Tube 16mm OD Compression - Chrome

Cautions

Thermaltake recommends the following steps to be taken after completing your water loop setup:

1. It is strongly recommended to use market-proven pre-mixed coolant, such as Thermaltake Coolant 1000, which offers great performance while preventing corrosion in the entire cooling system (copper, brass, nickel, aluminum, and steel).
2. Fill the reservoir with coolant and cycle the power on and off several times while the pump pushes the coolant into the loop.
3. DO NOT let the pump run dry. If no liquid is entering the pump, turn off the power immediately.
4. Fill the reservoir to the top to prevent air from entering the pump.
5. If necessary, tilt the system slightly from side to side to bleed the air out of the loop.
6. Place paper towels under fittings and joining points to test for leaks.
7. Run the loop with the fill port open for about 24 hours to completely bleed the air out of the loop.
8. Before starting, flush out the system properly to prevent any coolant or unwanted particles from sticking to your tubes, radiators, and other cooling components.
9. Coolant might fade over time.